How To Install Bathroom Sink Drain Stopper

Installing a bathroom sink drain stopper is a relatively simple plumbing task that can be completed in a few minutes. However, there are a few essential aspects to consider to ensure a proper installation. ### Gather the Necessary Tools and Materials Before you begin, you will need to gather the following tools and materials: - Adjustable wrench - Plumber's putty - New drain stopper - Screwdriver (optional) ### Remove the Old Drain Stopper Begin by removing the old drain stopper. Use an adjustable wrench to loosen the retaining nut that is located underneath the sink. Once the nut is loose, you can remove the stopper by pulling it up through the drain hole. ### Clean the Drain Hole Once the old stopper is removed, take some time to clean the drain hole. Remove any debris or old plumber's putty that may be present. This will help to ensure a good seal for the new stopper. ### Apply Plumber's Putty Roll out a small piece of plumber's putty into a rope. Apply the putty to the base of the new stopper, making sure to create a seal around the edges. ### Install the New Drain Stopper Insert the new drain stopper into the drain hole. Hand-tighten the retaining nut until it is snug. Do not overtighten the nut, as this could damage the stopper or the sink. ### Test the Drain Stopper Turn on the water and allow it to run for a few minutes. Check for any leaks around the drain stopper. If there are any leaks, tighten the retaining nut further. ### Conclusion Installing a bathroom sink drain stopper is a simple task that can be completed in a few minutes. By following these essential steps, you can ensure a proper installation that will prevent leaks and maintain the functionality of your sink.