How To Install Kohler Bathroom Sink Drain

Installing a Kohler bathroom sink drain is a relatively simple process that can be completed in a few hours. However, it is important to follow the instructions carefully to ensure a proper installation. Here are the essential aspects of how to install a Kohler bathroom sink drain:

Tools and materials:

Adjustable wrench
Plumber's putty
Drain flange gasket
Drain stopper
Pop-up drain assembly

Steps:

Remove the old drain: Use an adjustable wrench to loosen the nuts holding the old drain in place. Once the nuts are loose, you can remove the drain by hand.
Clean the drain hole: Use a damp cloth to clean the drain hole of any debris. This will help to ensure that the new drain fits properly.
Apply plumber's putty: Roll a small piece of plumber's putty into a rope and place it around the base of the new drain flange. This will help to seal the drain and prevent leaks.
Place the drain flange gasket: Place the drain flange gasket over the drain hole. This gasket will help to create a watertight seal between the drain and the sink.
Insert the pop-up drain assembly: Insert the pop-up drain assembly into the drain hole. The pop-up drain assembly will have a stopper that will close the drain when it is not in use.
Secure the pop-up drain assembly: Use the adjustable wrench to tighten the nuts that hold the pop-up drain assembly in place. Be sure not to overtighten the nuts, as this could damage the drain assembly.
Install the drain stopper: Insert the drain stopper into the pop-up drain assembly. The drain stopper will prevent water from flowing out of the drain when it is closed.

Once you have installed the new drain, turn on the water to test it for leaks. If there are any leaks, tighten the nuts that hold the drain assembly in place until the leaks stop.