How To Remove Bathroom Sink Stopper American Standard

How to Remove Bathroom Sink Stopper American Standard

American Standard bathroom sink stoppers are designed to prevent water from draining out of the sink. They can be removed for cleaning or replacement. Here are the steps involved in removing an American Standard bathroom sink stopper:

1. Gather your materials. You will need a pair of pliers, a screwdriver, and a bucket.

2. Turn off the water supply to the sink. This is usually done by turning off the valves under the sink.

3. Remove the drain cover. The drain cover is usually held in place by two screws. Remove the screws with a screwdriver and lift off the drain cover.

4. Loosen the stopper. The stopper is held in place by a nut. Use a pair of pliers to loosen the nut.

5. Remove the stopper. Once the nut is loose, you can remove the stopper by pulling it straight up.

6. Clean the stopper and drain. Use a mild soap and water solution to clean the stopper and drain. Rinse thoroughly with water.

7. Reinstall the stopper. Insert the stopper into the drain and tighten the nut by hand. Use the pliers to tighten the nut further, but do not overtighten.

8. Reinstall the drain cover. Place the drain cover back over the drain and secure it with the two screws.

9. Turn on the water supply to the sink. Check for leaks around the stopper.

Tips:

If the stopper is stuck, you can try using a penetrating oil to loosen it.
Be careful not to overtighten the nut when reinstalling the stopper.
If you are replacing the stopper, make sure to get the correct size and type for your sink.

Removing an American Standard bathroom sink stopper is a relatively simple process that can be completed in a few minutes. By following the steps outlined above, you can easily remove and replace the stopper as needed.