How To Replace A Bathroom Sink Tap Washer

Replacing a bathroom sink tap washer is a simple plumbing task that can be completed in a few minutes. By following these steps, you can save yourself the cost of calling a plumber.

The first step is to turn off the water supply to the sink. This is usually done by turning the handles on the shut-off valves located under the sink. Once the water is turned off, you can remove the old washer by unscrewing the packing nut that holds it in place. Be careful not to lose the small spring that is located behind the washer.

Once the old washer is removed, you can insert the new washer into the packing nut. Make sure that the washer is seated properly and that the spring is in place. Then, tighten the packing nut until it is snug. Do not overtighten the packing nut, as this can damage the washer.

Once the new washer is installed, you can turn the water supply back on and check for leaks. If there are any leaks, you can tighten the packing nut a little more. Once the leaks are stopped, you can finish the job by replacing the handle on the tap.

Replacing a bathroom sink tap washer is a simple task that can be completed in a few minutes. By following these steps, you can save yourself the cost of calling a plumber.