How to Replace a Bathroom Sink Cabinet in 8 Easy Steps
Is your bathroom sink cabinet looking a little worse for wear? Maybe it's starting to rot, or maybe it's just outdated. Whatever the reason, replacing a bathroom sink cabinet is a relatively simple project that you can easily do yourself. Here's a step-by-step guide to help you get started.
Step 1: Gather Your Tools and Materials
Before you start, you'll need to gather all the tools and materials you'll need for the job. Here's a list to get you started:
- New bathroom sink cabinet
- Screwdriver
- Drill
- Level
- Measuring tape
- Caulk gun
- Caulk
- Plumber's putty
Step 2: Remove the Old Cabinet
Once you have all your tools and materials, you can start removing the old cabinet. Here's how to do it:
- Turn off the water supply to the sink.
- Disconnect the drain line and water supply lines from the sink.
- Remove the screws that are holding the cabinet in place.
- Carefully remove the cabinet from the wall.
Step 3: Install the New Cabinet
Now it's time to install the new cabinet. Here's how to do it:
- Place the new cabinet in the space where the old cabinet was.
- Level the cabinet using a level.
- Drill pilot holes for the screws.
- Drive the screws into the pilot holes to secure the cabinet to the wall.
Step 4: Reconnect the Sink
Once the cabinet is installed, you can reconnect the sink. Here's how to do it:
- Apply plumber's putty to the rim of the sink.
- Place the sink on top of the cabinet.
- Tighten the nuts on the sink to secure it to the cabinet.
- Reconnect the drain line and water supply lines to the sink.
- Turn on the water supply to the sink.
Step 5: Caulk the Edges of the Sink
Once the sink is reconnected, you can caulk the edges of the sink to prevent water from leaking. Here's how to do it:
- Apply a bead of caulk around the edges of the sink.
- Smooth the caulk with your finger or a caulk tool.
Step 6: Install the Hardware
Once the caulk is dry, you can install the hardware on the cabinet. This includes the knobs, pulls, and handles. Here's how to do it:
- Mark the location of the hardware on the cabinet.
- Drill pilot holes for the hardware.
- Insert the hardware into the pilot holes.
- Tighten the screws to secure the hardware.
Step 7: Finishing Touches
Once the hardware is installed, you're almost finished. Here are a few finishing touches to complete the project:
- Clean up any mess that you made.
- Inspect the cabinet to make sure that it's level and secure.
- Enjoy your new bathroom sink cabinet!
How To Install A Bathroom Vanity
How To Install A Bathroom Vanity
How To Remove A Bathroom Vanity Budget Dumpster
Replace Vanity Top And Faucet Diy Network
How To Remove Replace A Vanity Top Easy Bathroom Sink Remodel
11 Low Cost Ways To Replace Or Redo A Hideous Bathroom Vanity Hometalk
11 Low Cost Ways To Replace Or Redo A Hideous Bathroom Vanity Hometalk
How To Replace Install A Bathroom Vanity And Sink Small Vanities Diy Trendy