How To Install Moen Bathroom Sink Stopper

Installing a Moen bathroom sink stopper is a relatively simple task that can be completed in a few minutes. However, it is important to follow the instructions carefully to ensure that the stopper is installed correctly and will function properly. This article will provide step-by-step instructions on how to install a Moen bathroom sink stopper.

Before you begin, you will need to gather the following tools and materials:

Phillips head screwdriver
Adjustable wrench
New Moen bathroom sink stopper
Plumber's putty

Once you have gathered your tools and materials, you can begin the installation process.

Step 1: Remove the old stopper

To remove the old stopper, simply unscrew the Phillips head screw that is located in the center of the stopper. Once the screw is removed, you will be able to pull the stopper out of the sink.

Step 2: Clean the sink drain

Once the old stopper is removed, you should clean the sink drain to remove any debris or build-up. You can do this by using a drain cleaner or by pouring a cup of baking soda down the drain followed by a cup of vinegar. Let the baking soda and vinegar sit for 15 minutes, then flush the drain with hot water.

Step 3: Apply plumber's putty to the new stopper

Before you install the new stopper, you will need to apply a ring of plumber's putty to the base of the stopper. This will help to create a watertight seal between the stopper and the sink.

Step 4: Install the new stopper

To install the new stopper, simply insert it into the sink drain and tighten the Phillips head screw until it is snug. Do not overtighten the screw, as this could damage the stopper or the sink.

Step 5: Test the stopper

Once the stopper is installed, you should test it to make sure that it is working properly. To do this, simply fill the sink with water and then press down on the stopper. The stopper should seal the drain and prevent the water from draining out.

If the stopper is not working properly, you may need to adjust the tension of the spring. To do this, simply use a Phillips head screwdriver to turn the adjustment screw that is located on the side of the stopper. Turning the screw clockwise will increase the tension of the spring, while turning the screw counterclockwise will decrease the tension of the spring.

Once you have adjusted the tension of the spring, test the stopper again to make sure that it is working properly.

Installing a Moen bathroom sink stopper is a simple task that can be completed in a few minutes. By following the instructions in this article, you can ensure that the stopper is installed correctly and will function properly.