How To Remove A Bathroom Vanity With Floor Plumbing

How to Remove a Bathroom Vanity with Floor Plumbing: A Comprehensive Guide

Removing a bathroom vanity with floor plumbing may seem daunting, but it's actually quite manageable with the right preparation and tools. This detailed guide will guide you through each step, ensuring a smooth and successful removal.

Materials Required:

Adjustable wrench
Plumber's putty
Rag or sponge
Measuring tape
Screwdriver
Bucket
Pliers
Basin wrench (optional)

Safety Precautions:

Before starting, turn off the water supply to the vanity. Ensure that the sink drain is closed to prevent water from leaking during the removal process.

Step 1: Disconnect the Water Supply

Locate the water supply lines underneath the sink. Use an adjustable wrench to loosen the nuts connecting the lines to the faucet valves. Catch any dripping water with a bucket.

Step 2: Remove the Drain Pipe

Underneath the sink, find the drain pipe connected to the sink's drain assembly. Use pliers or a basin wrench to loosen the nut holding the pipe to the assembly. Disconnect the pipe and place a rag over the open drain to prevent debris from entering the plumbing system.

Step 3: Measure and Protect Fixtures

Measure the distance between the two water supply lines underneath the sink. This will determine the width of the new vanity. If you have a countertop, remove it and set it aside for reuse or disposal.

Step 4: Disconnect the Vanity

Most vanities are secured to the wall or floor with screws or bolts. Use a screwdriver or wrench to remove these fasteners. Gently lift the vanity straight up until it separates from the plumbing.

Step 5: Remove Floor Plumbing

Once the vanity is removed, you may need to disconnect the floor plumbing if it's connected to the vanity. Use an adjustable wrench to loosen the nuts connecting the vanity drain to the floor drain. Apply plumber's putty around the base of the new floor drain before connecting it to the vanity drain.

Step 6: Reinstall the Vanity

Position the new vanity in place and align it with the plumbing fixtures. Secure it to the wall or floor using the same fasteners removed earlier.

Step 7: Reconnect Water Supply and Drain

Reconnect the water supply lines and tighten the nuts. Reconnect the drain pipe and tighten the nut. Turn on the water supply and check for leaks at all connections.

Step 8: Install Countertop and Fixtures

Reinstall the countertop and any fixtures, such as the faucet and drain assembly. Ensure that everything is securely attached and functioning properly.

Congratulations! You have successfully removed your old bathroom vanity and installed a new one with floor plumbing. By following these steps carefully, you can tackle this project with confidence and enjoy a fresh and functional bathroom.