How To Remove A Nutone Bathroom Exhaust Fan With Light

Nutone bathroom exhaust fans with lights are a common fixture in many homes. They help to remove moisture and odors from the bathroom, and they also provide additional lighting. However, over time, these fans can become dirty or damaged, and they may need to be replaced. If you're planning to replace a Nutone bathroom exhaust fan with light, follow these steps:

1. Gather Your Tools and Materials

Before you begin, make sure you have the following tools and materials:

Phillips head screwdriver
Flat head screwdriver
Wire cutters
Safety glasses
Gloves
New Nutone bathroom exhaust fan with light
Replacement light bulb
Caulk gun
Caulk

2. Turn Off the Power

Before you do anything else, turn off the power to the bathroom exhaust fan. You can do this by flipping the circuit breaker that controls the fan or by removing the fuse that powers the fan.

3. Remove the Light Cover

Once the power is turned off, remove the light cover from the exhaust fan. The light cover is usually held in place by a few screws. Once you've removed the screws, the light cover should come off easily.

4. Disconnect the Wires

Once the light cover is removed, you'll see the wires that connect the fan to the power supply. Disconnect the wires by carefully cutting them with wire cutters. Be sure to wear safety glasses and gloves when you're doing this.

5. Remove the Mounting Screws

Once the wires are disconnected, you can remove the mounting screws that hold the fan in place. There are usually four mounting screws, located at the corners of the fan housing. Once you've removed the mounting screws, the fan should come down easily.

6. Clean the Area

Before you install the new fan, take a moment to clean the area where the old fan was located. This will help to ensure that the new fan fits properly and that it operates efficiently.

7. Install the New Fan

Once the area is clean, you're ready to install the new fan. To do this, simply reverse the steps that you took to remove the old fan. First, insert the new fan into the housing and secure it with the mounting screws. Then, connect the wires to the power supply. Finally, replace the light cover.