How To Replace A Washer In Bathroom Tap

Replacing a washer in a bathroom tap is a simple plumbing task that can be completed in a few minutes. By following these step-by-step instructions, you can easily fix a leaky tap and save money on plumbing costs.

Step 1: Gather your tools and materials

You will need the following tools and materials to replace a washer in a bathroom tap:

Adjustable wrench
Flathead screwdriver
New washer
Vaseline or plumber's grease

Step 2: Turn off the water supply

The first step is to turn off the water supply to the bathroom tap. Locate the shut-off valves under the sink and turn them clockwise to close them.

Step 3: Remove the aerator

The aerator is a small device attached to the end of the bathroom tap. It helps to aerate the water and reduce splashing. To remove the aerator, use an adjustable wrench to loosen it and then unscrew it by hand.

Step 4: Remove the handle

The next step is to remove the handle of the bathroom tap. Use a flathead screwdriver to pry off the cap that covers the handle screw. Once the screw is exposed, use an adjustable wrench to loosen it and then remove the handle.

Step 5: Remove the packing nut

The packing nut is a large nut that holds the tap in place. Use an adjustable wrench to loosen the packing nut and then remove it by hand.

Step 6: Remove the washer

The washer is a small rubber or plastic disc that seals the tap and prevents water from leaking. Use a flathead screwdriver to pry out the old washer.

Step 7: Install the new washer

Apply a small amount of Vaseline or plumber's grease to the new washer and then insert it into the tap. Make sure that the washer is seated properly and is not twisted.

Step 8: Reassemble the tap

Reassemble the tap in the reverse order of disassembly. Tighten the packing nut, install the handle, and replace the aerator. Finally, turn on the water supply and check for leaks.