How Do You Change A Bathroom Sink Tap

How to Change a Bathroom Sink Tap

Replacing a bathroom sink tap is a relatively straightforward task that can be completed in a few hours. By following these step-by-step instructions, you can save money and time by doing it yourself.

What You'll Need

New bathroom sink tap
Adjustable wrench
Basin wrench
Plumber's putty
Teflon tape
Bucket
Screwdriver (optional)
Flashlight (optional)

Step 1: Turn Off the Water Supply

Before you begin, turn off the water supply to the sink. There should be two shut-off valves located under the sink, one for hot water and one for cold water. Turn both valves clockwise until they are completely closed.

Step 2: Remove the Old Tap

Use an adjustable wrench to loosen the nuts that hold the tap in place. Once the nuts are loose, you can remove the tap by pulling it straight up. If the tap is stuck, you can use a basin wrench to get a better grip.

Step 3: Clean the Sink Surface

Once the old tap is removed, clean the surface of the sink where the new tap will be installed. Remove any old plumber's putty or debris.

Step 4: Apply Plumber's Putty

Apply a ring of plumber's putty around the base of the new tap. The putty will help to create a watertight seal.

Step 5: Install the New Tap

Insert the new tap into the hole in the sink. Make sure that the tap is centered and that the putty is evenly distributed around the base. Tighten the nuts that hold the tap in place using an adjustable wrench. Do not overtighten the nuts.

Step 6: Connect the Water Supply Lines

Connect the water supply lines to the new tap. Use Teflon tape to wrap around the threads of the water supply lines before connecting them to the tap. This will help to prevent leaks.

Step 7: Turn On the Water Supply

Once the water supply lines are connected, turn on the water supply and check for leaks. If there are any leaks, tighten the nuts that hold the tap in place or adjust the Teflon tape.