How Do You Remove A 3 Hole Bathroom Faucet

How to Remove a 3 Hole Bathroom Faucet

Replacing a bathroom faucet is a simple plumbing task that typically takes less than an hour. The only special tools you'll need are an adjustable wrench, a pair of pliers, and a few screwdrivers.

Here are the steps on how to remove a 3 hole bathroom faucet:

1. Turn off the water supply.

There should be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water supply.

2. Disconnect the water supply lines.

Use the adjustable wrench to loosen the nuts that connect the water supply lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines.

3. Remove the mounting nuts.

There will be two or three mounting nuts that hold the faucet in place. Use the adjustable wrench to loosen the nuts until they are hand-tight, and then remove them by hand.

4. Lift the faucet out of the sink.

Once the mounting nuts are removed, you should be able to lift the faucet straight up out of the sink.

5. Clean the sink surface.

Once the faucet is removed, take a few minutes to clean the sink surface. This will help to prevent any leaks from occurring when you install the new faucet.

6. Install the new faucet.

Follow the instructions that came with the new faucet to install it. Be sure to tighten all of the nuts and screws securely, but do not overtighten them.

7. Turn on the water supply.

Once the new faucet is installed, turn on the water supply valves under the sink. Check for any leaks, and if you find any, tighten the nuts or screws until they stop.

Replacing a 3 hole bathroom faucet is a relatively simple plumbing task that can be completed in less than an hour. By following these steps, you can avoid any potential problems and ensure that your new faucet is installed correctly.