How To Change A Delta Bathroom Faucet Washer

How to Change a Delta Bathroom Faucet Washer

A Delta bathroom faucet is a popular choice for homeowners due to its durability and ease of use. However, over time, the faucet washer may need to be replaced. A worn-out washer can cause the faucet to leak, which can waste water and increase your water bill. Replacing the washer is a relatively simple task that can be completed in a few minutes.

Here are the essential steps on how to change a Delta bathroom faucet washer:

1. Gather your tools. You will need a Phillips screwdriver, a flathead screwdriver, and a new faucet washer. 2. Turn off the water supply to the faucet. There are typically two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water. 3. Open the faucet to release any remaining water. This will help prevent water from leaking out when you remove the faucet handle. 4. Remove the faucet handle. Most Delta faucet handles are held in place by a single screw. Use the Phillips screwdriver to remove the screw, then pull the handle straight up to remove it. 5. Remove the packing nut. The packing nut is located beneath the faucet handle. Use the flathead screwdriver to loosen the packing nut, then remove it by hand. 6. Remove the old washer. The old washer is located inside the packing nut. Use your fingernail or a small screwdriver to pry the old washer out. 7. Install the new washer. Place the new washer inside the packing nut, making sure that it is seated correctly. 8. Reinstall the packing nut. Hand-tighten the packing nut, then use the flathead screwdriver to tighten it further. Be careful not to overtighten the packing nut, as this can damage the faucet. 9. Reinstall the faucet handle. Align the faucet handle with the stem and push it down until it is fully seated. Secure the handle with the screw. 10. Turn on the water supply to the faucet. Slowly turn on the hot and cold water valves under the sink until the faucet is fully pressurized. 11. Check for leaks. Open the faucet and check for any leaks around the handle or base of the faucet. If there are any leaks, tighten the packing nut or the faucet handle screw further. Congratulations! You have now successfully replaced the washer in your Delta bathroom faucet. Here are some additional tips for changing a Delta bathroom faucet washer:

If you are not comfortable replacing the washer yourself, you can call a plumber to do it for you.
Be sure to purchase the correct size washer for your faucet. The size of the washer will be stamped on the old washer.
If the packing nut is difficult to remove, you can use a wrench to loosen it.
When tightening the packing nut, be sure to tighten it evenly so that the washer is not damaged.
If you have any questions about changing a Delta bathroom faucet washer, consult the manufacturer's instructions or call a plumber.