How To Change A Washer On Bathroom Sink Faucet

The washer on a bathroom sink faucet is a small, rubber or plastic ring that creates a seal between the faucet and the sink. Over time, the washer can become worn or damaged, causing the faucet to leak. Fortunately, changing a washer is a relatively simple and inexpensive repair that can be completed in a few minutes.

To change a washer on a bathroom sink faucet, you will need the following tools and materials:

A Phillips head screwdriver
A new washer
A pair of pliers
A bucket or bowl

Once you have gathered your tools and materials, follow these steps to change the washer:

1. Turn off the water supply to the faucet. There are usually two shut-off valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to turn off the water.

2. Open the faucet to release any remaining water in the lines.

3. Place the bucket or bowl under the faucet to catch any water that may leak out.

4. Use the pliers to remove the old washer. The washer is located inside the faucet handle. Use the pliers to gently pry the old washer out of the handle.

5. Inspect the faucet handle and the seat where the washer sits for any damage. If there is any damage, you may need to replace the faucet handle or the seat.

6. Place the new washer inside the faucet handle. Make sure that the washer is properly seated and that it is not twisted or damaged.

7. Reinstall the faucet handle. Use the pliers to tighten the handle until it is snug. Do not overtighten the handle, as this could damage the faucet.

8. Turn on the water supply to the faucet. Check for any leaks around the faucet handle. If there are any leaks, you may need to tighten the handle further or replace the washer.