How To Change Bathroom Faucet And Drain

How to Change a Bathroom Faucet and Drain

Replacing a bathroom faucet and drain is a relatively simple plumbing project that can be completed in a few hours with the right tools and materials. Here is a step-by-step guide to help you through the process:

Tools and Materials

Adjustable wrench
Plumber's putty
Teflon tape
New faucet
New drain assembly
Bucket
Rags

Once you have gathered your tools and materials, you can begin the process of replacing your bathroom faucet and drain.

Step 1: Turn Off the Water Supply

The first step is to turn off the water supply to the bathroom faucet. This is typically done by turning off the valves located under the sink. If there are no valves under the sink, you will need to turn off the main water supply to the house.

Step 2: Remove the Old Faucet

Once the water supply is turned off, you can begin removing the old faucet. To do this, use an adjustable wrench to loosen the nuts that are holding the faucet in place. Once the nuts are loose, you can carefully lift the faucet out of the sink.

Step 3: Install the New Faucet

Before installing the new faucet, apply a bead of plumber's putty to the base of the faucet. This will help to create a watertight seal. Once the plumber's putty is in place, you can insert the new faucet into the sink. Hand-tighten the nuts that are holding the faucet in place, and then use an adjustable wrench to tighten them further.

Step 4: Connect the Water Supply Lines

Once the new faucet is installed, you can connect the water supply lines. To do this, use a wrench to tighten the nuts that are connecting the water supply lines to the faucet. Be sure to use Teflon tape on the threads of the nuts to create a watertight seal.

Step 5: Install the New Drain Assembly

Once the water supply lines are connected, you can install the new drain assembly. To do this, first remove the old drain assembly by unscrewing the nuts that are holding it in place. Once the old drain assembly is removed, you can insert the new drain assembly into the drain hole. Hand-tighten the nuts that are holding the drain assembly in place, and then use a wrench to tighten them further.

Step 6: Test the New Faucet and Drain

Once the new faucet and drain are installed, you can turn on the water supply and test them to make sure that they are working properly. If there are any leaks, you can tighten the nuts that are holding the faucet and drain in place further. Once you are satisfied that the new faucet and drain are working properly, you can clean up any remaining plumber's putty or debris.

Conclusion

Replacing a bathroom faucet and drain is a relatively simple plumbing project that can be completed in a few hours. By following these steps, you can successfully replace your bathroom faucet and drain and save yourself the cost of hiring a plumber.