How To Change Out A Bathroom Sink Faucet

Replacing a bathroom sink faucet is a fairly simple plumbing project that most homeowners can do themselves. However, there are a few essential aspects of the job that you need to be aware of in order to do it correctly.

### Materials You'll Need:

New bathroom sink faucet
Wrench
Plumber's putty
Teflon tape
Basin wrench

### Steps on How to Change Out a Bathroom Sink Faucet: 1.

Turn off the water supply.

The first step is to turn off the water supply to the sink. There will be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to close them. 2.

Disconnect the old faucet.

Once the water supply is turned off, you can disconnect the old faucet. To do this, use a wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can pull the faucet up and off the sink. 3.

Clean the sink.

Before you install the new faucet, it's a good idea to clean the sink. This will help to ensure a good seal and prevent leaks. Use a mild detergent and water to clean the sink, and then rinse it thoroughly. 4.

Apply plumber's putty.

The next step is to apply plumber's putty to the base of the new faucet. Plumber's putty is a sticky substance that helps to seal the faucet and prevent leaks. To apply plumber's putty, roll it into a rope and then place it around the base of the faucet. 5.

Install the new faucet.

Once the plumber's putty is in place, you can install the new faucet. To do this, insert the faucet into the hole in the sink and then tighten the nuts that hold it in place. Be sure to tighten the nuts securely, but don't overtighten them or you could damage the faucet. 6.

Connect the water supply.

Once the faucet is installed, you can connect the water supply. To do this, use a wrench to tighten the nuts that connect the water lines to the faucet. Be sure to tighten the nuts securely, but don't overtighten them or you could damage the water lines. 7.

Turn on the water supply.

Once the water supply is connected, you can turn on the water supply and check for leaks. If there are any leaks, tighten the nuts that connect the water lines to the faucet until the leaks stop. ### Conclusion Replacing a bathroom sink faucet is a relatively simple plumbing project that most homeowners can do themselves. By following these steps, you can save yourself the cost of hiring a plumber and get the job done right.