How To Fit Bathroom Basin Waste

How to Fit Bathroom Basin Waste

Replacing or installing a bathroom basin waste is a simple plumbing task that can be completed in a few minutes with the right tools and materials. Here's a step-by-step guide on how to fit basin waste:

Tools and Materials:

Adjustable wrench
New basin waste
Plumber's putty
Washer
Sealant (optional)

Step 1: Remove the Old Waste

Start by turning off the water supply to the basin. Then, use an adjustable wrench to loosen the nuts that hold the waste in place. Once the nuts are loose, remove the old waste by pulling it out of the basin.

Step 2: Prepare the New Waste

Apply a small amount of plumber's putty to the rim of the new waste. This will help create a seal between the waste and the basin.

Step 3: Insert the New Waste

Insert the new waste into the basin. Ensure that the putty is evenly distributed around the rim.

Step 4: Tighten the Nuts

Hand-tighten the nuts onto the waste as much as possible. Then, use an adjustable wrench to further tighten the nuts. Be careful not to overtighten the nuts, as this could damage the waste.

Step 5: Install the Washer

Place the washer over the tailpiece of the waste. This washer will create a seal between the waste and the trap.

Step 6: Connect the Trap

Connect the trap to the tailpiece of the waste. Ensure that the trap is securely tightened to prevent leaks.

Step 7: Apply Sealant (Optional)

For added protection against leaks, apply a small amount of sealant around the base of the waste. Smooth the sealant using your finger.

Step 8: Test the Waste

Turn on the water supply to the basin and check for any leaks. If there are no leaks, the waste has been fitted correctly.

Tips: