How To Fix Leaking Tap In Bathroom

How to Fix a Leaking Tap in the Bathroom

A leaking tap in the bathroom can be a frustrating and costly problem. Not only can it waste water, but it can also damage your bathroom fixtures and floors. If you're facing this issue, don't despair. Fixing a leaking tap is a relatively simple task that you can do yourself with a few basic tools. Here are some things to help you fix a leaking tap in the bathroom: ### Tools and Materials You'll Need - Adjustable wrench - Allen wrench - Flathead screwdriver - Phillips screwdriver - Replacement washer (if necessary) - Plumber's tape - Soft cloth ### Step-by-Step Instructions 1.

Turn off the water supply.

The first step is to turn off the water supply to the tap. This will prevent water from leaking out while you're working on it. There should be a shut-off valve located under the sink or behind the toilet. Turn the valve clockwise to turn off the water. 2.

Remove the aerator.

The aerator is the small, perforated screen that's attached to the end of the tap. It helps to mix air into the water, which creates a more forceful stream. To remove the aerator, simply unscrew it by hand. If it's stuck, you can use a pair of pliers to gently loosen it. 3.

Remove the handle.

Once the aerator is removed, you'll need to remove the handle. Most handles are held in place by a small screw. Use a screwdriver to remove the screw, then pull the handle straight up. 4.

Remove the packing nut.

The packing nut is the large nut that's located behind the handle. It helps to keep the tap from leaking. Use an adjustable wrench to loosen the packing nut, then remove it by hand. 5.

Inspect the washer.

The washer is a small, rubber or plastic disc that's located inside the packing nut. It helps to create a watertight seal. Inspect the washer for any signs of damage or wear. If the washer is damaged, you'll need to replace it. 6.

Replace the washer.

If the washer is damaged, you'll need to replace it. To do this, simply insert the new washer into the packing nut. Make sure that the washer is facing the correct way. 7.

Reassemble the tap.

Once you've replaced the washer, you can reassemble the tap. Start by tightening the packing nut by hand. Then, use an adjustable wrench to tighten the packing nut further. Be careful not to overtighten the packing nut, as this can damage the tap. 8.

Turn on the water supply.

Once the tap is reassembled, you can turn on the water supply. Check for any leaks. If there are no leaks, you've successfully fixed the leaking tap. ### Conclusion Fixing a leaking tap is a relatively simple task that you can do yourself with a few basic tools. By following these steps, you can save yourself time and money, and keep your bathroom looking its best.