How To Get Scratches Off Bathroom Sink Drain Pipe

How to Remove Scratches From a Bathroom Sink Drain Pipe

Bathroom sink drain pipes can easily get scratched due to everyday use. These scratches can not only be unsightly, but they can also provide a breeding ground for bacteria and mold. Fortunately, there are several simple ways to remove scratches from a bathroom sink drain pipe.

Materials You'll Need:

Fine-grit sandpaper
Steel wool
Baking soda
Vinegar
Cloth

Step 1: Clean the Drain Pipe

Start by cleaning the drain pipe with warm water and soap to remove any dirt or debris. Use a cloth or sponge to wipe down the pipe.

Step 2: Sand the Scratches

If the scratches are deep, you may need to sand them down. Use fine-grit sandpaper and gently sand the scratches in a circular motion. Be careful not to sand too hard, as this could damage the pipe.

Step 3: Use Steel Wool

If the scratches are not too deep, you can use steel wool to remove them. Dampen the steel wool and gently rub it over the scratches in a circular motion. Rinse the pipe with water when you're finished.

Step 4: Make a Baking Soda Paste

Mix baking soda with a little bit of water to form a paste. Apply the paste to the scratches and let it sit for 10-15 minutes. Rinse the pipe with water.

Step 5: Apply Vinegar

After you've rinsed the baking soda paste, apply some vinegar to the scratches. Let it sit for a few minutes and then rinse the pipe with water. The vinegar will help to brighten the pipe and remove any remaining stains.

Step 6: Dry the Pipe

Once you've finished cleaning the drain pipe, dry it thoroughly with a cloth. This will help to prevent any moisture from getting trapped in the scratches and causing rust.

Tips:

If the scratches are very deep, you may need to replace the drain pipe.
Be careful not to use harsh chemicals to clean the drain pipe, as this could damage the finish.
Clean the drain pipe regularly to prevent scratches from forming in the first place.