How To Install Bathroom Basin Waste

How to Install Bathroom Basin Waste

Installing a bathroom basin waste is a relatively straightforward task that can be completed in under an hour. However, it is important to follow the steps carefully to ensure that the waste is installed correctly and does not leak.

Materials You Will Need

New bathroom basin waste
Adjustable wrench
Plumber's putty or silicone sealant
Rag

Step 1: Remove the Old Waste

Start by turning off the water supply to the basin. Then, use an adjustable wrench to loosen the locknut that holds the old waste in place. Once the locknut is loose, you can remove the old waste by pulling it straight up.

Step 2: Clean the Basin Drain

Once the old waste is removed, take a rag and clean the basin drain. Remove any debris or old sealant that may be present.

Step 3: Apply Plumber's Putty or Silicone Sealant

If you are using plumber's putty, roll out a small piece of putty and form it into a ring. Place the ring of putty around the base of the new waste.

If you are using silicone sealant, apply a bead of sealant around the base of the new waste.

Step 4: Insert the New Waste

Insert the new waste into the basin drain. Push down on the waste until it is fully seated.

Step 5: Tighten the Locknut

Use the adjustable wrench to tighten the locknut that holds the waste in place. Do not overtighten the locknut, as this can damage the waste.

Step 6: Connect the Waste Pipe

Connect the waste pipe to the outlet of the waste. Tighten the nuts on the waste pipe using the adjustable wrench.

Step 7: Turn on the Water Supply

Turn on the water supply to the basin and check for leaks. If you see any leaks, tighten the locknut or waste pipe nuts as needed.

Tips

If you are not confident in your ability to install a bathroom basin waste, it is best to call a plumber.
Make sure that the new waste is the correct size for your basin. The waste should have a diameter of 1 1/4 inches.
If the old waste is made of metal, it may be difficult to remove. You may need to use a hammer and chisel to break up the waste.
Be careful not to overtighten the locknut or waste pipe nuts, as this can damage the waste or pipe.
If you are using plumber's putty, make sure that the putty is applied evenly around the base of the waste.

Installing a bathroom basin waste is a simple task that can be completed in under an hour. By following the steps outlined in this article, you can ensure that the waste is installed correctly and does not leak.