How To Install Single Handle Bathroom Faucet

How to Install a Single-Handle Bathroom Faucet

Replacing an old or faulty bathroom faucet can be a straightforward task that adds a touch of elegance and functionality to your bathroom. Here's a comprehensive guide on how to install a single-handle bathroom faucet:

Tools and Materials You'll Need:

- Adjustable wrench - Basin wrench - Phillips screwdriver - Plumber's putty - Teflon tape - New single-handle bathroom faucet

Step 1: Gather Your Materials and Prepare the Work Area

Ensure you have all the necessary tools and materials before starting the installation. Clear the work area around the faucet and spread old towels or cloths to protect the countertop and floor.

Step 2: Shut Off the Water Supply

Locate the shut-off valves under the sink or behind the toilet and turn them off. If you can't find them, you may need to turn off the main water supply to your house.

Step 3: Remove the Old Faucet

Using a basin wrench, loosen the nuts that secure the old faucet to the sink. Carefully lift the old faucet off the sink.

Step 4: Clean the Sink

Remove any old plumber's putty or debris from the sink surface where the new faucet will be installed. Use a damp cloth to clean the area.

Step 5: Apply Plumber's Putty

Roll a rope of plumber's putty into a circle and press it around the base of the new faucet. This will help seal the faucet and prevent leaks.

Step 6: Install the Faucet

Position the new faucet over the sink and align the holes. Tighten the nuts underneath using the basin wrench until they are snug but not overtightened.

Step 7: Connect the Water Supply Lines

Wrap Teflon tape around the threads of the water supply lines and screw them into the corresponding hot and cold valves on the faucet. Hand-tighten them as much as possible.

Step 8: Tighten the Nuts

Using an adjustable wrench, tighten the nuts that secure the water supply lines to the faucet. Again, tighten them snugly but avoid overtightening.

Step 9: Install the Handle

Locate the handle assembly and insert it into the handle hole on the faucet. Secure it with the included screw.

Step 10: Turn on the Water Supply

Slowly turn on the shut-off valves under the sink or behind the toilet. Check for any leaks and tighten any loose connections as needed.

Step 11: Final Checks

Run the water through the faucet for a few minutes to test its functionality. Check for any leaks, loose handles, or any unusual noises.

Conclusion

Installing a single-handle bathroom faucet is a relatively straightforward task that can be completed with basic tools and supplies. By following these steps, you can save money and upgrade your bathroom with a stylish and functional new faucet.