How To Remove A Bathroom Faucet And Drain

Replacing a bathroom faucet or drain is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Tools and Materials

Adjustable wrench
Basin wrench
Phillips screwdriver
Flathead screwdriver
New faucet and drain
Teflon tape
Plumber's putty

Step 1: Turn off the water supply

The first step is to turn off the water supply to the faucet. This is typically done by turning off the valves beneath the sink. If there are no valves, you will need to turn off the main water supply to the house.

Step 2: Disconnect the water lines

Once the water supply is turned off, you can disconnect the water lines from the faucet. Use an adjustable wrench to loosen the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines.

Step 3: Remove the old faucet

Once the water lines are disconnected, you can remove the old faucet. Use a basin wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can pull the faucet out of the sink.

Step 4: Clean the sink

Before installing the new faucet, it is important to clean the sink. This will help to ensure that the new faucet will fit properly and that there will be no leaks.

Step 5: Install the new faucet

Once the sink is clean, you can install the new faucet. First, apply a thin layer of Teflon tape to the threads of the faucet. This will help to prevent leaks. Next, insert the faucet into the sink and tighten the nuts that hold it in place.

Step 6: Connect the water lines

Once the faucet is installed, you can connect the water lines. Use an adjustable wrench to tighten the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines.

Step 7: Turn on the water supply

Once the water lines are connected, you can turn on the water supply. Check for leaks around the faucet and the drain. If there are any leaks, tighten the nuts that hold the faucet and drain in place.

Step 8: Install the new drain

If you are also replacing the drain, you will need to remove the old drain before installing the new one. To remove the old drain, use a flathead screwdriver to loosen the screws that hold the drain in place. Once the screws are loose, you can pull the drain out of the sink.

To install the new drain, first apply a thin layer of plumber's putty to the rim of the drain. This will help to create a watertight seal. Next, insert the drain into the sink and tighten the screws that hold it in place.

Step 9: Enjoy your new faucet and drain

Once the new faucet and drain are installed, you can enjoy the benefits of your new plumbing fixtures. Be sure to keep the faucet and drain clean to prevent leaks and ensure that they last for many years to come.