How To Remove Bathroom Tub Spout

How to Remove a Bathroom Tub Spout Effortlessly

Replacing a bathroom tub spout is a relatively straightforward task that can be completed in under an hour with the right tools and a bit of knowledge. By following these easy-to-follow steps, you can efficiently remove your old spout and install a new one.

Tools You'll Need:

Adjustable wrench or pliers
Allen wrench or hex key (in some cases)
Cloth or towel

Step 1: Turn Off the Water Supply

Locate the shut-off valves under the sink or behind the access panel in the bathroom. Turn both the hot and cold water valves clockwise to stop the water flow to the tub.

Step 2: Open the Tub Faucet

Open the tub faucet to release any remaining water pressure in the lines. Keep the faucet open until no more water comes out.

Step 3: Remove the Aerator (Optional)

If your tub spout has an aerator, it needs to be removed before you can access the spout itself. Use an adjustable wrench or pliers to gently unscrew the aerator counterclockwise.

Step 4: Locate the Set Screw

On most tub spouts, you'll find a small set screw on the side or underside of the spout. Use an Allen wrench or hex key to loosen the set screw by turning it counterclockwise.

Step 5: Remove the Spout

Once the set screw is loose, grasp the spout and pull it straight towards you. It may require some gentle rocking back and forth to break the seal. Wrap a cloth or towel around the spout to protect the finish if necessary.

Step 6: Clean the Threads

Use a damp cloth to clean the threads on the tub wall where the spout was attached. Remove any debris or mineral deposits that may interfere with the installation of the new spout.

Step 7: Install the New Spout

Align the threads of the new spout with the threads on the tub wall and hand-tighten it as far as possible. Use an adjustable wrench or pliers to gently tighten the spout further, taking care not to overtighten.

Step 8: Tighten the Set Screw

Locate the set screw on the new spout and tighten it using an Allen wrench or hex key. This will help secure the spout in place.

Step 9: Turn On the Water Supply

Slowly turn on the shut-off valves under the sink to reintroduce water flow to the tub. Check for any leaks around the new spout and tighten the set screw or the spout itself if necessary.

Step 10: Reinstall the Aerator (Optional)

If you removed the aerator earlier, screw it back onto the spout by hand-tightening it clockwise. Do not overtighten.

Congratulations! You have successfully removed and replaced your bathroom tub spout. Enjoy your updated and refreshed bathroom.