How To Remove Metal Ring Around Bathroom Sink

How to Remove the Metal Ring Around Your Bathroom Sink

Over time, the metal ring around your bathroom sink can become discolored, corroded, or simply unsightly. If you're looking to restore your sink to its former glory, removing the metal ring is a relatively simple task that can be completed in just a few steps.

Materials You'll Need

* Adjustable wrench * Plumber's putty * Utility knife * Rags * Vinegar (optional)

Step-by-Step Instructions

1. Turn Off the Water Supply

* Locate the water supply valves under the sink and turn them off to prevent water from flowing into the sink while you work.

2. Remove the Drain Stopper

* Use your adjustable wrench to loosen and remove the drain stopper.

3. Loosen the Metal Ring

* Place the adjustable wrench around the metal ring and turn it counterclockwise to loosen it. Be careful not to overtighten the wrench, as you could damage the ring or the sink.

4. Remove the Metal Ring

* Once the metal ring is loose, carefully lift it off the sink. If it's stuck, gently tap it with a rubber mallet to loosen it.

5. Clean the Surface

* Use a rag and some vinegar to clean the surface of the sink where the metal ring was located. This will remove any remaining residue or corrosion.

6. Apply Plumber's Putty

* Roll out a small amount of plumber's putty into a rope and place it around the edge of the sink where the metal ring will go. This will create a watertight seal.

7. Reinstall the Metal Ring

* Place the metal ring over the plumber's putty and press it firmly into place. Use your adjustable wrench to tighten the ring clockwise until it's snug.

8. Reinstall the Drain Stopper

* Install the drain stopper back into the sink and tighten it with your adjustable wrench.

9. Turn On the Water Supply

* Turn on the water supply valves under the sink to restore water flow to the sink.

10. Check for Leaks

* Run water into the sink and check for any leaks around the metal ring. If you notice any leaks, tighten the ring further using your adjustable wrench.

Tips for Preventing Future Corrosion

* Regularly clean the metal ring with a mild cleaning solution to prevent buildup. * Apply a thin layer of petroleum jelly to the metal ring to protect it from moisture. * Avoid using abrasive cleaners or harsh chemicals on the metal ring.