How To Remove Your Bathroom Sink

How to Remove a Bathroom Sink

Removing a bathroom sink is a relatively simple task that can be completed in a few hours. By following these steps, you can safely and easily remove your bathroom sink.

Gather Your Tools and Materials

Before you begin, you will need to gather the following tools and materials:

Adjustable wrench
Basin wrench
Putty knife
Bucket
New putty or silicone sealant

Turn Off the Water Supply

The first step is to turn off the water supply to the sink. This is typically done by turning off the valves located under the sink. If there are no valves, you will need to turn off the main water supply to your home.

Disconnect the Water Lines

Once the water supply is turned off, you can disconnect the water lines from the sink. Use an adjustable wrench to loosen the nuts that hold the water lines in place. Be careful not to overtighten the nuts, as this can damage the water lines.

Disconnect the Drain

Next, you need to disconnect the drain from the sink. Use a basin wrench to loosen the nuts that hold the drain in place. Be careful not to damage the drain or the sink.

Remove the Sink

Once the water lines and drain are disconnected, you can remove the sink. Carefully lift the sink up and off of the countertop. Be careful not to drop the sink, as this could damage it.

Clean the Countertop

Once the sink is removed, you can clean the countertop. Use a putty knife to remove any old putty or silicone sealant from the countertop. Be careful not to damage the countertop.

Apply New Putty or Silicone Sealant

Before you install the new sink, you need to apply a new bead of putty or silicone sealant to the countertop. This will help to create a watertight seal between the sink and the countertop.

Install the New Sink

Now you can install the new sink. Carefully lower the sink into place on the countertop. Be sure to align the sink with the drain hole. Once the sink is in place, tighten the nuts that hold it in place.

Reconnect the Water Lines and Drain

Once the sink is installed, you can reconnect the water lines and drain. Use an adjustable wrench to tighten the nuts that hold the water lines in place. Be careful not to overtighten the nuts, as this can damage the water lines. Use a basin wrench to tighten the nuts that hold the drain in place. Be careful not to damage the drain or the sink.

Turn on the Water Supply

Once the water lines and drain are reconnected, you can turn on the water supply. Check for leaks around the sink and the drain. If you see any leaks, tighten the nuts until the leaks stop.