How To Replace A Bathroom Vanity With Floor Plumbing

Replacing a bathroom vanity with floor plumbing can be a daunting task, but with the right preparation and materials, it can be completed in a few hours. Here is a step-by-step guide to help you get the job done:

Step 1: Gather Your Materials

Before you start, make sure you have all the necessary materials. You will need:

A new bathroom vanity
A new sink
A new faucet
A p-trap
A supply line kit
A level
A tape measure
A screwdriver
A wrench
A hammer
Caulk

Step 2: Remove the Old Vanity

Once you have your materials, you can start removing the old vanity. First, turn off the water supply to the vanity. Then, disconnect the water supply lines from the faucet. Next, remove the screws that are holding the vanity to the wall. Finally, carefully lift the vanity off the floor and set it aside.

Step 3: Install the New Vanity

Now it's time to install the new vanity. First, place the vanity in the desired location. Then, level the vanity using a level and shims. Once the vanity is level, secure it to the wall using screws.

Step 4: Install the Sink

Next, install the sink. First, apply a bead of caulk around the rim of the sink. Then, place the sink in the vanity and press it firmly into place. Finally, secure the sink to the vanity using screws.

Step 5: Install the Faucet

Now it's time to install the faucet. First, attach the faucet to the sink. Then, connect the water supply lines to the faucet. Finally, turn on the water supply and check for leaks.

Step 6: Install the P-Trap

The p-trap is a U-shaped pipe that prevents sewer gases from entering the bathroom. To install the p-trap, first attach one end of the p-trap to the drainpipe under the sink. Then, attach the other end of the p-trap to the drainpipe in the floor. Finally, tighten the nuts on both ends of the p-trap.

Step 7: Connect the Supply Lines

Now it's time to connect the supply lines. First, attach one end of the supply lines to the water shut-off valves under the sink. Then, attach the other end of the supply lines to the faucet. Finally, turn on the water supply and check for leaks.

Step 8: Caulk the Vanity

Finally, caulk the vanity to seal it and prevent water damage. To caulk the vanity, first apply a bead of caulk around the base of the vanity. Then, smooth the caulk using your finger or a caulk tool. Finally, allow the caulk to dry completely.

Replacing a bathroom vanity with floor plumbing is a relatively simple task that can be completed in a few hours. By following these steps, you can save yourself the cost of hiring a plumber and get the job done right.