How To Replace A Leaky Bathroom Sink Faucet

How to Replace a Leaky Bathroom Sink Faucet

A leaky faucet can be not only an annoyance but also a waste of water and money. Replacing a leaky faucet is a relatively simple task that can be completed in a few hours. With the right tools and materials, you can save yourself the cost of hiring a plumber.

Tools and Materials

Adjustable wrench
Phillips screwdriver
Allen wrench (if necessary)
New faucet
Plumber's putty
Teflon tape
Bucket
Rags

Step-by-Step Instructions

1. Turn Off the Water Supply

Before you begin, turn off the water supply to the faucet. There should be two valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to shut off the water.

2. Remove the Old Faucet

Use the adjustable wrench to loosen the nuts that hold the faucet in place. Be careful not to overtighten the nuts, as this can damage the faucet.

Once the nuts are loose, remove the old faucet by pulling it straight up. Be careful not to splash water on yourself.

3. Clean the Sink

Use a rag to clean the sink around the base of the faucet. Remove any old sealant or debris.

4. Apply Plumber's Putty

Roll out a rope of plumber's putty and apply it around the base of the new faucet. Press the putty into place to create a seal.

5. Install the New Faucet

Insert the new faucet into the sink and push it down until it is flush with the counter.

Use the adjustable wrench to tighten the nuts that hold the faucet in place. Again, be careful not to overtighten the nuts.

6. Wrap Teflon Tape

Wrap Teflon tape around the threads of the water supply lines. This will help to create a watertight seal.

7. Connect the Water Supply Lines

Connect the water supply lines to the faucet. Make sure that the hot water line is connected to the hot water valve and the cold water line is connected to the cold water valve.

8. Turn On the Water Supply

Slowly turn on the water supply valves under the sink. Check for any leaks around the base of the faucet or the water supply lines.

9. Test the Faucet

Turn on the faucet and check for any leaks. If there are any leaks, tighten the nuts that hold the faucet in place or the water supply lines until the leaks stop.

Congratulations! You have now successfully replaced a leaky bathroom sink faucet.