How To Replace A Pop Up Bathroom Sink Plug

How to Replace a Pop-Up Bathroom Sink Plug

Replacing a pop-up bathroom sink plug is a relatively simple plumbing task that can be completed in a few minutes. However, it is important to follow the steps carefully to ensure that the new plug is installed correctly and will not leak.

Here are the steps on how to replace a pop-up bathroom sink plug:

1. Gather the necessary tools and materials.

New pop-up bathroom sink plug
Adjustable wrench
Plumber's putty
Rags

2. Turn off the water supply to the sink.

Locate the water supply valves under the sink and turn them off. This will prevent water from flowing out of the sink while you are replacing the plug.

3. Remove the old pop-up plug.

Use an adjustable wrench to loosen the nut that holds the old pop-up plug in place. Once the nut is loose, you can pull the old plug out of the sink.

4. Clean the sink drain.

Use a rag to clean the sink drain of any debris. This will help to ensure that the new plug will fit properly.

5. Apply plumber's putty to the new pop-up plug.

Roll a small piece of plumber's putty into a snake shape and wrap it around the base of the new pop-up plug. This will help to seal the plug and prevent leaks.

6. Insert the new pop-up plug into the sink drain.

Push the new pop-up plug into the sink drain until it is seated firmly. Hand-tighten the nut that holds the plug in place.

7. Turn on the water supply to the sink.

Turn on the water supply valves under the sink. Check for leaks around the new pop-up plug. If there are any leaks, tighten the nut further.

Replacing a pop-up bathroom sink plug is a simple plumbing task that can be completed in a few minutes. By following these steps, you can ensure that the new plug is installed correctly and will not leak.