How To Replace A Rusted Bathroom Sink Drain Stopper From Leaking

How to Replace a Rusted Bathroom Sink Drain Stopper

Leaking sink drains can be a nuisance and can lead to water damage if left unchecked. If the drain stopper is rusted, it may be time to replace it. Replacing a rusted bathroom sink drain stopper is a relatively simple task that can be completed in a few minutes with the right tools.

In this article, we'll guide you through the steps on how to replace a rusted bathroom sink drain stopper. We'll cover the essential aspects of the task, including the necessary tools, materials, safety precautions, and step-by-step instructions.

Tools and Materials

New drain stopper
Adjustable wrench
Plumber's putty
Rags or towels

Safety Precautions

Turn off the water supply to the sink before starting.
Wear gloves to protect your hands from sharp edges.
Use caution when handling the old drain stopper as it may be rusty and sharp.

Step-by-Step Instructions

Remove the old drain stopper: Loosen the nut underneath the sink using an adjustable wrench. Once the nut is loose, pull out the old drain stopper.
Clean the drain hole: Remove any debris or old plumber's putty from the drain hole. Use a rag or towel to wipe away any rust or dirt.
Apply plumber's putty: Roll a small piece of plumber's putty into a snake shape. Wrap the putty around the base of the new drain stopper.
Insert the new drain stopper: Push the new drain stopper into the drain hole. Tighten the nut underneath the sink until it is snug, but do not overtighten.
Turn on the water supply: Slowly turn on the water supply and check for any leaks. If you see any leaks, tighten the nut further.

Conclusion

Replacing a rusted bathroom sink drain stopper is a straightforward task that can be completed in a few minutes with the right tools and materials. By following these step-by-step instructions and observing the essential aspects of the task, you can ensure a successful replacement and prevent future leaks.