How To Replace A Washer In Bathroom Sink Drain
The washer is a small, rubber component that sits in the sink drain and creates a watertight seal. Over time, the washer can deteriorate and cause the sink to leak. Replacing a washer is a simple and relatively inexpensive repair that you can do yourself.
Materials- New washer
- Adjustable wrench
- Bucket or bowl
- Plumber's putty (optional)
Before you begin, turn off the water supply to the sink. Then, open the faucet to release any residual water from the lines.
Step 1: Remove the Drain StopperLocate the drain stopper in the center of the sink. Use a flathead screwdriver or a coin to pry the stopper out of place.
Step 2: Remove the Drain AssemblyBeneath the drain stopper, you will see a metal drain assembly. Use an adjustable wrench to loosen the nut that holds the assembly in place.
Step 3: Remove the Old WasherOnce you have removed the drain assembly, you will see the old washer. Use your fingers or a pair of pliers to remove the washer from the bottom of the drain assembly.
Step 4: Apply Plumber's Putty (Optional)If you want to create a more watertight seal, you can apply a small amount of plumber's putty around the bottom of the new washer.
Step 5: Install the New WasherPlace the new washer into the bottom of the drain assembly. Make sure that the washer is properly seated and that it is facing the correct direction.
Step 6: Reinstall the Drain AssemblyScrew the drain assembly back into place. Use the adjustable wrench to tighten the nut, but do not overtighten it.
Step 7: Reinstall the Drain StopperPut the drain stopper back into place and press down firmly to secure it.
Step 8: Turn on the Water SupplyTurn on the water supply to the sink and check for leaks. If you see any leaks, tighten the nut on the drain assembly further.
Tips- If you are having trouble removing the old washer, you can try using a pair of needle-nose pliers.
- If you do not have any plumber's putty, you can use petroleum jelly instead.
- If you are still having problems with the sink leaking, you may need to call a plumber.
Replacing a washer in a bathroom sink drain is a simple repair that you can do yourself in a few minutes. By following the steps in this article, you can save yourself the cost of calling a plumber.
How To Install Bathroom Sink Drain Queen Bee Of Honey Dos
Leaking Tap Learn How To Change A Washer
How To Replace A Sink Stopper Quick And Simple Home Repair
How To Install Bathroom Sink Drain Queen Bee Of Honey Dos
How To Fix Or Replace A Leaky Sink Trap Hometips
Learn The 7 Diy Steps To Replace Your Tap Washer Blog
Installing A New Bathroom Sink
How To Install Bathroom Sink Drain Queen Bee Of Honey Dos
How To Change A Washer On Mixer Tap Living By Homeserve
Installing A New Bathroom Sink