How To Replace Bathroom Basin Tap

Replacing a bathroom basin tap is a relatively straightforward task that can be completed in a few hours. However, it is important to ensure that you have the correct tools and materials before you start. In this article, we will provide you with a step-by-step guide on how to replace a bathroom basin tap, as well as a list of the essential tools and materials you will need.

### Essential Tools and Materials

Before you begin, you will need to gather the following tools and materials:

Adjustable wrench
Plumber's putty
Teflon tape
New bathroom basin tap
Bucket
Cloth

### Step-by-Step Guide to Replacing a Basin Tap ### Step 1: Turn Off the Water Supply

The first step is to turn off the water supply to the bathroom basin. There will usually be two isolation valves under the basin, one for hot water and one for cold water. Turn both valves clockwise to turn off the water supply.

### Step 2: Remove the Old Tap

Once the water supply is turned off, you can start to remove the old tap. Use the adjustable wrench to loosen the nuts that hold the tap in place. Be careful not to over-tighten the nuts, as this could damage the tap.

### Step 3: Clean the Basin

Once the old tap is removed, you should clean the basin thoroughly. Use a cloth and some cleaning solution to remove any dirt or debris. This will help to ensure that the new tap is fitted correctly.

### Step 4: Apply Plumber's Putty

Apply a bead of plumber's putty around the base of the new tap. This will help to seal the tap and prevent any leaks. Be sure to smooth out the putty so that it is evenly distributed.

### Step 5: Wrap the Threads in Teflon Tape

Wrap the threads of the new tap in Teflon tape. This will help to create a watertight seal and prevent any leaks. Wrap the tape clockwise around the threads, starting from the bottom.

### Step 6: Install the New Tap

Place the new tap in the basin and tighten the nuts by hand. Once the nuts are hand-tight, use the adjustable wrench to tighten them further. Be careful not to over-tighten the nuts, as this could damage the tap.

### Step 7: Turn on the Water Supply

Once the new tap is installed, turn on the water supply. Check for any leaks. If there are any leaks, tighten the nuts further until the leaks stop.

### Step 8: Final Adjustments

Once the tap is installed and there are no leaks, you can make any final adjustments. This may include adjusting the position of the tap or the flow rate of the water.

### Conclusion

Replacing a bathroom basin tap is a relatively straightforward task that can be completed in a few hours. By following these simple steps, you can save yourself the cost of hiring a plumber. However, if you are not confident in your ability to complete the task, it is always best to seek professional help.