How To Replace Bathroom Vanity Light

How to Replace a Bathroom Vanity Light

Replacing a bathroom vanity light is a relatively simple task that can be completed in a few steps. By following the instructions below, you can easily update the look of your bathroom and ensure that it has adequate lighting.

Tools and Materials You'll Need:

New vanity light fixture
Screwdriver
Wire cutters
Electrical tape
Step stool or ladder

Step-by-Step Instructions:

Turn off the power. Before you begin working on the light fixture, make sure to turn off the power at the circuit breaker or fuse box.
Remove the old light fixture. Using a screwdriver, remove the screws that are holding the old light fixture in place. Carefully disconnect the wires from the fixture and pull it away from the wall.
Connect the wires to the new fixture. Strip about 1/2 inch of insulation from the ends of the wires. Twist the bare ends of the wires from the new fixture together with the corresponding wires from the wall. Wrap electrical tape around each connection to secure it.
Mount the new light fixture. Hold the new light fixture up to the wall and align the screw holes. Insert the screws and tighten them until the fixture is secure.
Turn on the power. Once the new fixture is installed, turn the power back on at the circuit breaker or fuse box. Test the light to make sure it is working properly.

Additional Tips:

If you are not comfortable working with electricity, it is best to hire a licensed electrician.
Make sure to choose a new vanity light fixture that is the same size as the old one. This will ensure that it fits properly and does not leave any gaps around the edges.
If you are replacing a fluorescent light fixture with an LED light fixture, you will need to remove the ballast from the old fixture. The ballast is a small, black box that is typically located on the side of the fixture.