How To Take Apart Bathroom Sink Drain

A bathroom sink drain is an essential part of the plumbing system in your home. It allows water to flow from the sink and down into the drainpipe. Over time, the drain can become clogged with hair, soap scum, and other debris. This can lead to slow drainage or even a complete blockage. If you find that your bathroom sink drain is not draining properly, you may need to take it apart and clean it.

Taking apart a bathroom sink drain is not a difficult task, but it does require some basic tools and knowledge. In this article, we will provide you with step-by-step instructions on how to take apart a bathroom sink drain and clean it.

Tools You Will Need:

Adjustable wrench
Phillips head screwdriver
Flat head screwdriver
Bucket or bowl
Rags

Step-by-Step Instructions:

1. Turn off the water supply to the sink. There should be two valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to turn off the water supply.

2. Open the drain stopper. The drain stopper is usually located in the center of the drain. Use your fingers or a screwdriver to lift the stopper up and out of the drain.

3. Remove the drain strainer. The drain strainer is located just below the drain stopper. Use your fingers or a screwdriver to lift the strainer up and out of the drain.

4. Loosen the slip nut. The slip nut is located at the bottom of the drain assembly. Use an adjustable wrench to loosen the slip nut by turning it counterclockwise.

5. Remove the drain assembly. Once the slip nut is loose, you can remove the drain assembly by pulling it straight up and out of the drain.

6. Clean the drain assembly. Once you have removed the drain assembly, you can clean it by soaking it in a solution of hot water and vinegar. Use a brush or a rag to scrub away any debris.

7. Reassemble the drain assembly. Once the drain assembly is clean, you can reassemble it by reversing the steps above. Start by inserting the drain assembly into the drain and tightening the slip nut. Then, insert the drain strainer and the drain stopper.

8. Turn on the water supply to the sink and check for leaks. Once you have reassembled the drain assembly, turn on the water supply to the sink and check for leaks. If there are any leaks, tighten the slip nut further.