How To Replace Bathroom Sink Taps

How to Replace Bathroom Sink Taps: A Comprehensive Guide

Replacing bathroom sink taps is a relatively simple plumbing task that can be completed in a few hours with the right tools and materials. Here's a step-by-step guide to help you get the job done:

Materials You'll Need:

New bathroom sink taps
Adjustable wrench
Channel-lock pliers
Teflon tape
Bucket or bowl
Rag or sponge

Step 1: Turn Off the Water Supply

Before you start working on the taps, make sure to turn off the water supply to the sink. There should be two shut-off valves located underneath the sink, one for hot water and one for cold water. Turn both valves clockwise to close them.

Step 2: Disconnect the Old Taps

Use the adjustable wrench to loosen the nuts that hold the old taps in place. Be careful not to overtighten the nuts, as this could damage the sink. Once the nuts are loose, you can use the channel-lock pliers to pull the old taps out of the sink.

Step 3: Clean the Sink Surface

Once the old taps are removed, take a rag or sponge and wipe down the surface of the sink. This will help to remove any debris or dirt that could interfere with the installation of the new taps.

Step 4: Install the New Taps

Take the new taps and wrap a few layers of Teflon tape around the threads of the mounting nuts. This will help to create a watertight seal. Next, insert the taps into the sink and tighten the mounting nuts using the adjustable wrench.

Step 5: Reconnect the Water Supply

Once the new taps are installed, you can reconnect the water supply. Turn on the shut-off valves underneath the sink and check for any leaks. If you see any leaks, tighten the mounting nuts a little more.

Step 6: Test the Taps

Turn on the taps and let the water run for a few minutes. Check for any leaks or drips. If you see any leaks, tighten the mounting nuts or adjust the position of the taps until the leaks stop.