Replacing Faucets In Bathroom Sink

Replacing Faucets In Bathroom Sink: A Comprehensive Guide

Replacing a bathroom sink faucet is a relatively straightforward task that can be completed in a few hours with the right tools and materials. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber and ensure that your new faucet is installed correctly.

Tools and Materials You'll Need

Adjustable wrench
Basin wrench
Pliers
Screwdriver
New faucet
Plumber's putty
Teflon tape

Step-by-Step Instructions

1. Turn off the water supply

The first step is to turn off the water supply to your sink. There should be two shut-off valves located under the sink, one for hot water and one for cold water. Turn both valves clockwise to close them.

2. Disconnect the old faucet

Once the water supply is turned off, you can proceed to disconnect the old faucet. Use a basin wrench to loosen the nuts that hold the faucet in place. Be careful not to overtighten the nuts, as this could damage the faucet or the sink.

3. Remove the old faucet

Once the nuts are loose, you can remove the old faucet from the sink. Be sure to keep all of the washers and O-rings that are attached to the faucet, as you will need to reuse them with the new faucet.

4. Apply plumber's putty

Before installing the new faucet, apply a bead of plumber's putty around the base of the faucet. This will help to seal the faucet and prevent water from leaking.

5. Install the new faucet

Place the new faucet in the sink and tighten the nuts that hold it in place. Be sure to tighten the nuts evenly so that the faucet is secure.

6. Connect the water supply

Once the faucet is installed, you can reconnect the water supply. Use a wrench to tighten the nuts that connect the water supply lines to the faucet. Be careful not to overtighten the nuts, as this could damage the faucet or the water supply lines.

7. Turn on the water supply

Turn on the water supply valves under the sink. Check for leaks around the faucet and the water supply lines. If there are any leaks, tighten the nuts or replace the washers and O-rings until the leaks stop.

Tips

If you are not comfortable replacing a faucet yourself, you can hire a plumber to do it for you.
When choosing a new faucet, be sure to select one that is compatible with your sink.
If you have hard water, you may need to install a water softener to prevent the faucet from scaling up.